SITE CONTENT

ECU by Part Number

ECU by Make and Model

ECU Wiring Diagrams

ABS Diagnostic Tools

Industry Links

ABS Troubleshooting for Trucks, Trailers, and Buses

STEP 4: Blink Codes for Knorr-Bremse A18 System ECU

1. Use the table to identify ABS faults from the ECU Blink Codes recorded in STEP 3: Blink code identification and system response
2. Links to solutions for common ABS faults can also be found below
3. Please ensure all necessary Health and Safety precautions are implemented before commencing any repair work
4. A list of useful ABS Diagnostic Tools is available on this website
5. If you require further help or information, please contact us

Knorr-Bremse A18 System ECU

Block 1

Block 2

Blink Code

Configuration

Blink Code

ABS Fault

2

2S/2M

1

No fault detected

2*

Wheel speed sensor - left

3*

Wheel speed sensor - right

8

Modulator valve - left

9

Modulator valve - right

11

ECU / Modulator ground

12

Power supply

13

Fault in equipment connected to 'UNI' circuit

14

ECU internal fault

*If the ECU detects an excessive air gap between sensor and sensor ring, the last pulse is double length (approximately 0.4sec).

© Copyright Drakefield Limited 2007-2008. All Rights Reserved.

Home | Contact | About | Privacy | Terms of Use | RSS Feeds

This website is owned and operated by: Drakefield Limited, Unit 60, Horndon Industrial Estate, Station Road, West Horndon, Essex, United Kingdom CM13 3XL Tel: +44 (0)1277 814060

Design: www.vibe-interactive.com