Block 1 | Block 2 |
Blink Code | Configuration | Blink Code | ABS Fault | ELF Fault |
1 | 2S/1M | 1 | No fault detected | No ELF faults |
2 | 2S/2M | 2* | Wheel speed sensor - DFA*** | ELF Height sensor - WS1*** |
3 | 4S/2M SR** | 3* | Wheel speed sensor - DFB*** | ELF Height sensor - WS2*** |
4 | 4S/2M AR** | 4* | Wheel speed sensor - DFC*** | ELF Pressure sensor - DS*** |
5 | 4S/3M | 5* | Wheel speed sensor - DFD*** |  |
| | 6* | Ground fault - GNDL*** | |
| | 7* | | Power output- UWS*** |
| | 8 | Modulator valve - MVA*** | ELF Control valve - WMVN*** |
| | 9 | Modulator valve - MVB*** | ELF Control valve - MVL*** |
| | 10 | Modulator valve - MVC*** | |
| | 11 | ECU / Modulator ground - GND*** | |
| | 12 | Power supply | |
| | 13 | Fault in circuit connected to 'UNI' pin | |
| | 14 | ECU internal fault | |
| | | | |
*If the ECU detects an excessive air gap between sensor and sensor ring, the last pulse is double length (approximately 0.4sec). |
**SR = Side for side control. AR = Axle for axle control |
***Signifies the connection on the ECU to which the faulty component is connected. Refer to relevant circuit diagram for A9 system |
