SITE CONTENT

ECU by Part Number

ECU by Make and Model

ECU Wiring Diagrams

ABS Diagnostic Tools

Industry Links

ABS Troubleshooting for Trucks, Trailers, and Buses

 

STEP 4: Blink Codes for Knorr-Bremse KB-91 A System ECU

  1. Use the table to identify ABS faults from the ECU Blink Codes recorded in STEP 3: Blink code identification and system response
  2. Links to solutions for common ABS faults can also be found below
  3. Please ensure all necessary Health and Safety precautions are implemented before commencing any repair work
  4. A list of useful ABS Diagnostic Tools is available on this website
  5. If you require further help or information, please contact us

Knorr-Bremse KB-91A System ECU

Blink Code

Location

Type of Fault

11

Red plug, sensor 2

Wheel speed sensor: Axle 1, left, short circuit or broken

12

Red plug, sensor 2

Wheel speed sensor: Axle 1, left, shorted coil, air gap too large or sensing ring damaged

13

Red plug, sensor 1

Wheel speed sensor: Axle 2, right, short circuit or broken

14

Red plug, sensor 1

Wheel speed sensor: Axle 2, right, shorted coil, air gap too large or sensing ring damaged

15

Blue plug, sensor 2

Wheel speed sensor: Axle 1, left, short circuit or broken

16

Blue plug, sensor 2

Wheel speed sensor: Axle 1, left, shorted coil, air gap too large or sensing ring damaged

17

Yellow plug, sensor 1

Wheel speed sensor: Axle 2, right, short circuit or broken

18

Yellow plug, sensor 1

Wheel speed sensor: Axle 2, right, shorted coil, air gap too large or sensing ring damaged

26

Red plug

Modulator: Axle 1, short circuit or broken

27

Blue plug

Modulator: Axle 2, left, short circuit or broken

28

Yellow plug

Modulator: Axle 2, right, short circuit or broken

32

If the error occurs despite power supply being O.K., replace ECU

Power cannot be disconnected

33

If the error occurs despite power supply being O.K., replace ECU

Power cannot be disconnected

42

Check installation

Variant 2S/1M recognised but different variation configured

43

Check installation

Variant 2S/2M recognised but different variation configured

44

Check installation

Variant 4S/2M recognised but different variation configured

47

Check installation

Variant 4S/3M recognised but different variation configured

49

No variant recognised

51

Cable not correctly installed or damaged exciter ring

Speed signal > 1500Hz

52

Faulty valve, wheel brake problem

Implausible valve error

99

Replace ECU

ECU: internal error

Number of pulses

Configuration

Plug connection for

Modulator

Sensor

2

2S/1M

---,---,Red

---,---,Red

3

2S/2M

Blue,Yel,---

Blue,Yel,---

4

4S/2M

Blue,Yel,---

Blue,Yel,Red

7

4S/3M

Blue,Yel,Red

Blue,Yel,Red

© Copyright Drakefield Limited 2007-2008. All Rights Reserved.

Home | Contact | About | Privacy | Terms of Use | RSS Feeds

This website is owned and operated by: Drakefield Limited, Unit 60, Horndon Industrial Estate, Station Road, West Horndon, Essex, United Kingdom CM13 3XL Tel: +44 (0)1277 814060

 

 

Design: www.vibe-interactive.com